BaySheet
Opening the sheet…
BaySheet
Opening the sheet…
Published repairs below cite a manual or a manufacturer chart. Coming soon pages are names only. Capacities and torque on this year stay on this year.
2017, 2018, and 2020 each use their own owner's manual. A with-filter oil quantity, a coolant quantity, a Motorcraft number, or a spark-plug gap from one of those years is not a specification for the other two.
Brake pad and rotor pages are filed for 2017, 2018, and 2020 from those printings. A dusty-road brake line or a brake-fluid change interval in one printing is not copied onto the others.
2015 and 2016 are the earlier years of the 2015–2017 body, and 2009–2014 is the body before that. Those years are not filed here. Their manuals were not the books read for these pages.
2024 tire pressure uses the August 2023 owner's manual edition. The cold pressure stays on that page, which points to the door label. 2025 is not filed. No 2025 owner's manual PDF was found.
Engine block heater pages are 2017, 2018, and 2020 only. The 2020 book adds an under-hood cord sentence the 2018 heater section does not print. A diesel cold-start temperature is not copied onto the 2017 page.
Copied from the published guides for this year. Each figure stays with that guide and that guide's source. Open the guide before you use it.
| Guide | Item | Figure |
|---|---|---|
| Tire pressure | Cold pressure | The recommended cold inflation pressure is on the tire label next to the tire size on the B-pillar or the edge of the driver door, and on the Safety Compliance Certification Label. That label is on the door hinge pillar, door-latch post, or the door edge that meets the door-latch on the B-pillar, or on the edge of the driver door. |
| Tire pressure | Hot check | If pressures are checked after the tires have been driven more than three minutes or more than 1 mile (2 km), pressure increases by approximately 4 psi (27.6 kPa). When adjusting then, the gauge reading should be 4 psi (27.6 kPa) greater than the recommended cold pressure. Recheck once the tires are cold. |
| Tire pressure | Information display | Do not use the tire pressure displayed in the information display as a tire pressure gauge. |
| Tire pressure | Tread | Replace the tires when the tread is worn down to 2/32 inch (1.6 mm). |
| Tire pressure | TPMS reset | Reset the system after each tire rotation on vehicles that require different recommended pressures in the front tires than in the rear tires. The procedure learns the left front, right front, right rear, and left rear sensors, then the tires are set to the label pressure. |