What oil does a 2025 Tacoma take?
Toyota Genuine Motor Oil or equivalent, ILSAC GF-6A, SAE 0W-20. With the filter the reference is 5.9 qt (5.6 L, 4.9 Imp. qt.). Without the filter it is 5.6 qt (5.3 L, 4.7 Imp. qt.), for the T24A-FTS.
BaySheet
Opening the sheet…
In-depth guide
2025 Toyota Tacoma
2025 Tacoma oil is ILSAC GF-6A SAE 0W-20. Drain-and-refill with the filter is 5.9 qt for the T24A-FTS.
| Item | Figure |
|---|---|
| Engine | T24A-FTS. Inline four, gasoline, turbocharged. Displacement 146.0 cu.in. (2393 cm³). Bore and stroke 3.44 × 3.91 in (87.5 × 99.5 mm). |
| With filter | 5.9 qt (5.6 L, 4.9 Imp. qt.). Reference quantity for a drain and refill. |
| Without filter | 5.6 qt (5.3 L, 4.7 Imp. qt.). Reference quantity. |
| Oil | Toyota Genuine Motor Oil or equivalent, ILSAC GF-6A. SAE 0W-20 is the recommended viscosity. If 0W-20 is unavailable, SAE 5W-20 may be used and must be replaced with 0W-20 at the next change. |
| Top-up span | 1.5 qt (1.4 L, 1.2 Imp. qt.) from the low level mark to the refill upper limit mark. That is not the drain capacity. |
Source: owner's manual / last verified 2026-10-16 (2025 Tacoma Owner's Manual, publication OM04011U, lubrication system (opens in a new tab)).
Difficulty, time, and cost are estimates when this guide gives them. Torque is a cited figure, or it is left off.
Main source: 2025 Tacoma Owner's Manual, publication OM04011U, lubrication system (opens in a new tab), Toyota Motor Sales, U.S.A., Inc., published 2026-05-22, read 2026-10-16.
Clean funnel
The adding-oil list names a clean funnel.
Rag
The level check says to hold a rag under the end of the dipstick.
| Item | Figure | Where it comes from |
|---|---|---|
| Engine | T24A-FTS. Inline four, gasoline, turbocharged. Displacement 146.0 cu.in. (2393 cm³). Bore and stroke 3.44 × 3.91 in (87.5 × 99.5 mm). | Specifications, engine |
| With filter | 5.9 qt (5.6 L, 4.9 Imp. qt.). Reference quantity for a drain and refill. | Lubrication system, oil capacity |
| Without filter | 5.6 qt (5.3 L, 4.7 Imp. qt.). Reference quantity. | Lubrication system, oil capacity |
| Oil | Toyota Genuine Motor Oil or equivalent, ILSAC GF-6A. SAE 0W-20 is the recommended viscosity. If 0W-20 is unavailable, SAE 5W-20 may be used and must be replaced with 0W-20 at the next change. | Engine oil selection |
| Top-up span | 1.5 qt (1.4 L, 1.2 Imp. qt.) from the low level mark to the refill upper limit mark. That is not the drain capacity. | Adding engine oil |
Park on level ground. With the engine at operating temperature, turn it off and wait about 5 minutes so the oil can drain back. Hold a rag under the dipstick, wipe it, seat it, and read it. The level should be above the low level mark.
Use Toyota Genuine Motor Oil or equivalent meeting ILSAC GF-6A. SAE 0W-20 is the best choice for fuel economy and cold starting. SAE 5W-20 may be used only if 0W-20 is unavailable, and it must be replaced with 0W-20 at the next change. Turn the filler cap counterclockwise, add oil slowly, and turn the cap clockwise. The top-up span from the low mark to the refill upper limit is 1.5 qt (1.4 L, 1.2 Imp. qt.).
The with-filter reference is 5.9 qt (5.6 L, 4.9 Imp. qt.). Without the filter it is 5.6 qt (5.3 L, 4.7 Imp. qt.). The capacity footnote says to warm the engine, turn it off, wait about 8 minutes, and check the dipstick, and not to exceed the refill upper limit. The maintenance steps say about 5 minutes. Both sentences are in this book.
On a 7-inch display, select the vehicle icon, open Vehicle Settings and hold, select Oil Maintenance, then Yes. On a 12.3-inch display, press and hold to show the cursor, select Settings, open Vehicle Settings and hold, select Oil Maintenance, then Yes.
The gas book read for this page is OM04011U. The hybrid book is a different publication and was not used. No oil-filter part number appears in the lubrication section that was read.
Outbound links only. BaySheet does not sell parts. Confirm fitment on the retailer page. Amazon links are searches for a real part name plus this vehicle. Tool rows do not get a product search. The search is not a part number.
Part
Toyota Genuine Motor Oil SAE 0W-20
ILSAC GF-6A. Recommended viscosity for the T24A-FTS in publication OM04011U.
2025 Tacoma lubrication system (opens in a new tab)Search Amazon.com (affiliate link) (opens in a new tab)As an Amazon Associate I earn from qualifying purchases.
Tool
Clean funnel
The adding-oil list names a clean funnel.
Tool
Rag
The level check says to hold a rag under the end of the dipstick.
Toyota Genuine Motor Oil or equivalent, ILSAC GF-6A, SAE 0W-20. With the filter the reference is 5.9 qt (5.6 L, 4.9 Imp. qt.). Without the filter it is 5.6 qt (5.3 L, 4.7 Imp. qt.), for the T24A-FTS.
About 5 minutes in the maintenance steps after a warm shutdown. About 8 minutes in the capacity footnote. The book prints both.
The maintenance checklist is on the site now. The email list is not sending yet, so this box will not store an address.
Same repair, different model year. Use the page that matches the truck or car in the driveway. A figure on one year is not a figure for the next.
These guides cover the same kind of work. Their numbers belong to those vehicles, not to this one.
Report an error to jordancoates@gmail.com.