Do the 2.5L and 3.5L share a plug?
No. FC16HR-Q8 is the 2.5L A25A-FKS. FK20HBR8 is the 3.5L 2GR-FKS. The gap printed once in the table is 0.031 in (0.8 mm), and the notice says not to adjust it.
BaySheet
Opening the sheet…
BaySheet
Opening the sheet…
In-depth guide
2020 Toyota Camry
2020 Toyota Camry spark plug numbers and gap for the 2.5L and 3.5L. The ignition table says not to adjust the gap.
Difficulty, time, and cost are estimates when this guide gives them. Torque is a cited figure, or it is left off.
Main source: Toyota 2020 Camry Owner's Manual (OM06158U), ignition system (opens in a new tab), Toyota Motor Sales, U.S.A., Inc., published 2020-03-31, read 2026-10-15.
Numbers on this page come from the cited source. Match the engine before you use a capacity or a torque. Do not work under a vehicle held only by a jack.
Toyota dealer
The notice says to use only iridium-tipped plugs and not to adjust the gap. It does not name a socket.
| Item | Figure | Where it comes from |
|---|---|---|
| 2.5L A25A-FKS | DENSO FC16HR-Q8. | Ignition system, spark plug make |
| 3.5L 2GR-FKS | DENSO FK20HBR8. | Ignition system, spark plug make |
| Gap | 0.031 in (0.8 mm). The table prints this once, after both part numbers. | Ignition system, gap |
The 2.5L A25A-FKS lists DENSO FC16HR-Q8. The 3.5L 2GR-FKS lists DENSO FK20HBR8.
The ignition table prints one gap, 0.031 in (0.8 mm). The notice says not to adjust an iridium-tipped plug.
These part numbers are cited from OM06158U. They are not carried over from the 2019 Camry page, even though that earlier book prints the same DENSO numbers.
Outbound links only. BaySheet does not sell parts. Confirm fitment on the retailer page. Amazon links are searches for the part name plus this vehicle. They are not a part number.
Part
DENSO plug listed for that engine
FC16HR-Q8 on the 2.5L. FK20HBR8 on the 3.5L. Gap 0.031 in (0.8 mm).
2020 Camry spark plug specification (opens in a new tab)Search Amazon.com (affiliate link) (opens in a new tab)
Tool
Toyota dealer
The notice says to use only iridium-tipped plugs and not to adjust the gap. It does not name a socket.
2020 Camry ignition system (opens in a new tab)Search Amazon.com (affiliate link) (opens in a new tab)
No. FC16HR-Q8 is the 2.5L A25A-FKS. FK20HBR8 is the 3.5L 2GR-FKS. The gap printed once in the table is 0.031 in (0.8 mm), and the notice says not to adjust it.
It is not printed in the ignition block that was read, so no sequence drawing is on this page.
The maintenance checklist is on the site now. The email list is not sending yet, so this box will not store an address.
These guides cover the same kind of work. Their numbers belong to those vehicles, not to this one.